Mr Butler’s – Sodamakers, Kitchen Appliances

Home \| Contact Us \| Order Now

	About Us Products Sodamaker Mixer Grinder Wet Grinder Induction Cooker Service & Support Store Locator


	FEEDBACK

	CUSTOMER SERVICE

	FAQ

	REPAIRS

Mr. Butler's Italia is so easy to operate, even kids can handle it with ease. Five easy steps is all it takes to get a litre of sparkling bubbling Soda or Soft Drink ready.

Step 1

	Fill water to the appropriate level * marked on the PET Bottle.
	Level I - To fill water for making carbonated Soft Drinks.
	Level II - To fill water for making Soda.
	Level III - For topping Concentrate after making Soda at level I.

Step 2

	Screw on Bottle into Soda maker - (2turns)

Step 3

	a) Press Operating Panel fully down till you notice the flow of Co2 gas into the PET Bottle.
	b) After 3 to 5 presses you will hear a hissing or reverberating sound.
	c) Continue pressing Operating Panel, 3 more times for light Soda and 6 times for regular Soda.
	* Never keep the Operating Panel pressed for more than one second continuously

Step 4

	Press Front Panel. Front Door Opens. Unscrew Bottle.

Step 5

	Your Soda is now ready for use. For making a Soft Drink, you may do the following steps
	a) Fill water up to the level "Water level for Soft drink"
	b) Carbonate the water to make Soda (Repeat step 3 of the above).
	c) Unscrew the Bottle from Soda maker
	d) Top up Soft Drink Concentrate up to "Fill Concentrate" level shown on the Bottle
	e) Screw on Cap, turn the Bottle upside down to allow Soft Drink Concentrate to mix with Soda.
	Your Fizzy Drink is now ready for immediate use. You can also store this drink in a refrigerator for use as and when required.

How do I clean my bottles?

Rinse bottles in lukewarm water only, with or without soap. Use a damp cloth to wipe dry. DO NOT wash in the dishwasher. DO NOT subject bottle to temperatures exceeding 50C. If the bottle bubbles excessively, it may be due to concentrate stains on the inside of the bottle. Rins well with warm water and soap.

Where is my local dealer/distributor?

Go to 'Customer Services'

My sodamaker does not carbonate, why?

Check whether the refill cylinder is empty. If yes, replace it with a filled one. If no, contact your nearest 'Service Centre'

How do I exchange my refill cylinder?

When your Mr.Butler's Refill Cylinder is empty, take the empty Cylinder to your nearest Dealer and exchange it for the cost of gas.

It's best to keep an extra Refill Cylinder at home so that you never run out of Soda and Soft drinks when you need it.

Ensure that you purchase Refills that are in a sealed wrapper having Mr.Butler's logo. Never use cylinders refilled by unauthorised refillers.

When a refill cylinder is being fitted to the sodamaker, the gas leaks without the operating panel being pressed?

The Rubber washer between the Cylinder Head Block, into which the Cylinder is screwed, and the Cylinder valve might have fallen off. Replace the washer. Use the spare washer placed at the back of the Sodamaker.

Why does water overflow sometimes from the carbonating bottle during carbonation?

Ensure that the water level does not exceed the 2nd level marking on the Bottle marked as 'Water Level For Soda'.

Each press of the Operating Panel must not exceed one second. Use short, firm presses only.

Can any type of bottle be used in Sodamaker?

No. Only genuine Mr. Butler's Bottles can be used. These are special Bottles made to withstand the carbonating pressure.

How many Sodas can be made with one cylinder?

175 glasses of Soda with the Mr.Butler's Italia and 100 glasses of soda with Mr.Butler's Instafizz. With the Italia 1 litre of Soda can be made at the cost of just a rupee.

How do I make aerated soft drink?

Fill water into the 1 litre Bottle till the lowest level marked 'Level For Softdrinks'

Make the soda.

Then pour the Soft Drink Concentrate up to level marked, 'Fill concentrate to this level only' after carbonation.

Cap the Bottle.

Turn the Bottle upside down to mix.

Fizzy Soft Drink is ready to be served.

Can I make and keep Sodas and soft drinks in the fridge for later use?

Yes, You can. In fact, we recommend you do just that. Purchase sufficient quantity of spare Bottles so that a large quantity of Sodas and Fizzy Soft Drinks can be made and stored. This will be particularly useful for parties.

The gas does not appear to flow freely when I press the operating lever, why?

The gas Cylinder is empty. Replace Gas Cylinder.

The jet in the Carbonating Pipe may be blocked. Take your Sodamaker to your Dealer or Autherised Service Center to rectify the blocked jet.